MxV LIN Go To Sleep Router

MxV_LIN_SleepRouter

This Transform receives the MxV LIN Go To Sleep System Signal (a Message Signal) and transmits an Event Signal to the outport corresponding to the bus specified in the transition. The GUID in the input message is matched to the BusId property of the output port. When you connect a Signal to an outport, a new port is added.

Use this procedure to set the BusId port properties:

1.Select the output port (not the Transform) on the CAN or LIN Transmit Driver Transform.
 
The port properties are displayed in the Properties box:

2.Copy the bus GUID from the Identification>GUID property of the CAN or LIN Transmit Driver Transform's outport. You can use Ctrl‑A to select and Ctrl‑C to copy.

Driver Outport Properties

Driver Outport Properties

3.Select the output port on the MxV Bus Enable Router.
 
The port properties are displayed in the Properties box:

MxV LIN Go To Sleep Router Output Port Properties

MxV LIN Go To Sleep Router Output Port Properties

4.Select the BusId port property and paste (or enter) the GUID of the corresponding bus. You can use Ctrl‑V to paste.

5.Connect the outport to the MxV LIN Go To Sleep port on the LIN Transmit Driver Transform.

6.Repeat for each output port that is connected to a bus.

See example for MxV LIN Wakeup Router.

Related Topic:

LIN Transforms

System Signals—Bus Control