1.Double-click on PeakOemDrv.exe.
2.When this box is displayed, click Next to continue.
3.Select the radio button shown below and click the Next button.
4.Click on the beside PCAN –Basic and select “Entire feature will be installed on local hard drive”.
5.After selecting PCAN-Basic, the image changes from to . Click the Next button to continue.
6.Click the Install button to start installation.
Installation in progress:
7.Click the Finish button to complete the installation.
This Transform is used to connect to PCAN USB devices. It can be configured with a CAN bus.
Use the drop-down list in the PCAN Device Selection>Selected Device property to select your device and channel. Note: If the device is not connected, the Configuration properties may not be displayed.